A1 Rotation can be used to create a (thin) even layer in a (closed) mould.
A1 Rotation is a 1:2 system and consists of A1 Rotation Liquid (1 part) and A1 Rotation Powder (2 parts), which are poured into a (closed) mould once mixed together. An even layer can then be created in the mould, either by hand or using a rotation machine. Keep rotating until the A1 Rotation has hardened.
You may find that you have to adjust the rotation speed and rotation angle to achieve even coverage in every corner of the mould. The end result may be a little fragile due to the thinner skin.
- Solvent free
- Low heat development (max 40°C)
- Shrinkage-free
- Environmentally friendly
- Very high fire-resistant properties
- UV stabilized
- Color pigments can be added
- Wide variety of surface structures
- Rainwater resistant (if sealed)
- Good mechanical properties
Acrylic One / A1 Rotation Resin
It is important to weigh and mix A1 very carefully, based on the following mixing ratio: 1 part A1 Liquid to 2 parts A1 Powder. Fill a mixing cup or bucket with the amount of A1 Liquid required. Use the stainless-steel High Shear Mixer to create a swirl and then add the A1 Powder. Stir the mix until smooth and lump-free and then stir for another 30 seconds. Make sure that the material on the bottom and sides of the cup or bucket is mixed in properly too.